Starting the Engine Using Remote Start

To start the engine using the remote start feature:

1. Aim the transmitter at the vehicle and press and release transmitter. on the transmitter.

2. Press and hold four seconds or until the for at least four seconds or until the vehicle's turn signal lamps flash.

The parking lamps will turn on and remain on as long as the engine is running. The vehicle's doors will be locked.

3. After entering the vehicle during a remote start, press the brake pedal and turn the ignition to ON/RUN to drive the vehicle.

After a remote start, the engine will automatically shut off after 10 minutes unless a time extension has been done or the ignition has been turned to ON/RUN.

    See also:

    Playing the Radio
    (Power/Volume): 1. Press to turn the audio system on and off. 2. Turn to increase or to decrease the volume. 3. Press and hold for more than two seconds to turn off the navigation system, the Rea ...

    Turn Signal Lamps
    To replace one of these bulbs: 1. Open the liftgate. See Liftgate . A. Push Pin B. Taillamp Cover 2. Pull on push pin (A) to release the taillamp cover (B). 3. Remove the taillamp cover ...

    Tire Sealant and Compressor Kit
    WARNING Idling a vehicle in an enclosed area with poor ventilation is dangerous. Engine exhaust may enter the vehicle. Engine exhaust contains carbon monoxide (CO) which cannot be seen or sm ...