Setting the Power Liftgate Intermediate Mode
To change the liftgate stop position:
1. Turn the liftgate switch to either the MAX, or the ¾ mode position and power open the liftgate.
2. Stop the liftgate movement at the desired height by pressing any button that operates the power liftgate, or the touch pad.
Manually adjust the liftgate position if required.
3. Press and hold the button on the liftgate adjacent to the latch until the turn signals flash and a beep sounds to indicate that the new setting is recorded.
When power opened with the ¾ mode selected, the liftgate stops at the new set position.
If an audible and visual response is not received when setting the intermediate stop position, the liftgate height is below the ¾ open height minimum, approximately 1.52m(5 ft) at the edge of the liftgate.
See also:
Emissions Inspection and Maintenance Programs
Some local governments may have programs to inspect the on-vehicle emission control
equipment. For the inspection, the emission system test equipment is connected to
the vehicle’s Data Link Connec ...
Flash-to-Pass
Use your high-beam headlamps to signal to a driver in front that you want to
pass. It works even if the headlamps are in the automatic position.
To use it, pull the turn signal lever toward you, th ...
Wiper Blades
Wiper blades need to be cleaned
and kept in good condition to
provide a clear view.
- Signs of wear include streaking,
skipping across the windshield,
and worn or split rubber.
- Trained dea ...