Programming the Power Windows
If the vehicle battery has been recharged, disconnected or not working, the front power windows will need to be reprogrammed for the express-up feature to work.
Before reprogramming, replace or recharge the vehicle's battery.
To program:
1. With the ignition in ON/RUN or ACC/ACCESSORY, or when Retained Accessory Power (RAP) is active, close all doors.
2. Press and hold the power window switch until the window is fully open.
3. Pull the power window switch up until the window is fully closed.
4. Continue holding the switch up for approximately two seconds after the window is completely closed.
The window is now reprogrammed.
Repeat the process for the other windows.
See also:
Engine Compartment
Fuse Block
(CTS Coupe and Sedan)
The underhood fuse block is
located on the left side of the engine
compartment.
Lift the fuse block cover to access
the fuses.
The vehicle may not be equipped
with all of the fuses and rel ...
Initial Drive Information
This section provides a brief overview about some of the important features
that may or may not be on your specific vehicle.
For more detailed information, refer to each of the features which can ...
Thigh Support Adjustment
If available, adjust the manual leg extension by pulling up on the lever,
and then pulling or pushing on the support to lengthen or shorten it.
Release the lever to lock it in place. ...






