Exit Lighting
This feature allows you to select the amount of time you want the exterior lamps to remain on when it is dark enough outside.
This happens after the key is turned from ON/RUN to LOCK/OFF.
Press the customization button until Exit Lighting appears on the DIC display. Press the set/reset button once to access the settings for this feature. Then press the menu up/down button to scroll through the following settings.
Off: The exterior lamps will not turn on.
10 Seconds (default): The exterior lamps will stay on for 10 seconds.
30 Seconds: The exterior lamps will stay on for 30 seconds.
2Minutes: The exterior lamps will stay on for two minutes.
No Change: No change will be made to this feature. The current setting will remain.
To select a setting, press the set/reset button while the desired setting is displayed on the DIC.
See also:
Limited-Slip Rear Axle
Vehicles with a limited-slip rear axle
can give more traction on snow,
mud, ice, sand, or gravel. When
traction is low, this feature allows
the drive wheel with the most
traction to move the ...
Removal and Installation of the Sealant Canister
To remove the sealant canister:
1. Unlock the air only hose (F) from the tire sealant canister (B) by pulling
up on the lever.
2. Pull the air only hose (F) from the tire sealant canister (B).
...
Sensors
The solar sensor located on the
instrument panel, near the
windshield, monitors the solar heat.
The interior temperature sensor,
located on the instrument panel to
the right of the steeri ...