Headlamp High/Low-Beam Changer
Push the turn signal/lane change lever away from you to turn the high beams on. Pull the lever toward you and then release it to return to low beams.
If the vehicle is turned off while the high beams are on, they will come on the next time the vehicle is started.
This indicator light turns on in the instrument panel cluster when the high–beam headlamps are on.
See also:
Engine Oil
To ensure proper engine
performance and long life, careful
attention must be paid to engine oil.
Following these simple, but
important steps will help protect
your investment:
- Always use e ...
Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the
washer fluid is low. The message is displayed for 15 seconds at the start of each
ignition cycle. When the WASHER FLUID ...
EPB Apply
The EPB can be applied any time
the vehicle is stopped. The EPB is
applied by momentarily lifting up on
the EPB switch. Once fully applied,
the BRAKE light will be on, and the
DIC message PA ...