Setting the Power Liftgate 3/4 Mode
To change the liftgate stop position.
1. Turn the liftgate switch to either the MAX, or the 3/4 mode position and
power open the liftgate.
2. Stop the liftgate movement at the desired height by pressing any liftgate
switch. Manually adjust the liftgate position if required.
3. Press and hold the button on the liftgate next to the latch until the turn
signals flash and a beep sounds to indicate that the new setting is recorded.
When power opened with the 3/4 mode selected, the liftgate stops at the new set position.
If you do not receive the audible and visual feedback when setting the intermediate stop position, you are attempting to set the height below the 3/4 open height minimum (approximately 1.52m or 5 ft).
The liftgate cannot be set below that minimum and the new setting will not be recorded.
See also:
Interior
The DTS can hold either five or six occupants, with a choice of front bucket
seats or a front bench. Compared with the DeVille, the instrument panel has been
lowered and moved forward. A new analo ...
Replacing Safety Belt System Parts after a Crash
WARNING!
A crash can damage the safety
belt system in the vehicle.
A damaged safety belt system
may not properly protect the
person using it, resulting in
serious injury or even death in a
...
Parking Brake
Set the parking brake by holding the regular brake pedal down, then pushing down
the parking brake pedal.
If the ignition is on, the brake system warning light will come on. See Brake
System Wa ...






