Tires
Every new GM vehicle has high-quality tires made by a leading tire manufacturer.
See the warranty manual for information regarding the tire warranty and where to get service. For additional information refer to the tire manufacturer.
WARNING!
- Poorly maintained and
improperly used tires are
dangerous.
- Overloading the tires can
cause overheating as a
result of too much flexing.
There could be a blowout and
a serious crash. See Vehicle
Load Limits.
- Underinflated tires pose the
same danger as overloaded
tires. The resulting crash
could cause serious injury.
Check all tires frequently to
maintain the recommended
pressure. Tire pressure
should be checked when the
tires are cold.
- Overinflated tires are more
likely to be cut, punctured,
or broken by a sudden
impact — such as when
hitting a pothole. Keep tires at
the recommended pressure.
- Worn or old tires can cause a
crash. If the tread is badly
worn, replace them.
- Replace any tires that have
been damaged by impacts
with potholes, curbs, etc.
- Improperly repaired tires can
cause a crash. Only the
dealer or an authorized tire
service center should repair,
replace, dismount, and mount
the tires.
- Do not spin the tires in
excess of 56 km/h (35 mph)
on slippery surfaces such
as snow, mud, ice, etc.
Excessive spinning may
cause the tires to explode.
See Tire Pressure for High-Speed Operation for inflation pressure adjustment for high-speed driving.
See also:
Side Blind Zone Alert (SBZA)
If available, this feature will alert you to vehicles located in the vehicle's
side blind zone. When the system detects a vehicle in the side blind zone, the SBZA
display will light up in the ...
Vehicle Messages
Messages displayed on the DIC indicate the status of the vehicle or some
action that may be needed to correct a condition. Multiple messages may display
one after the other.
The messages that do ...
Radio(s)
VOL/ : Press to turn the system
on and off. Turn to increase or
decrease the volume.
FM/AM: Press to select between
FM or AM.
: Press to select XM™,
if equipped.
TUNE/TONE: Turn to select ...