Front Turn Signal Lamp (Base and Uplevel)
To replace the Front Turn Signal Lamp:
1. Remove the turn signal lamp bulb socket from the headlamp assembly.
2. Remove the turn signal lamp bulb from the socket.
3. Replace the bulb in the bulb socket.
4. Install the bulb socket in the headlamp assembly.
5. For driver side, reinstall the underhood electrical center cover by latching
three clips.
6. For passenger side, reinstall the air filter/cleaner assembly base by
pushing to seat . Verify the base is seated securely, then install the engine
air filter/ cleaner assembly
See also:
Rear Vision Camera Location
The camera is located above the license plate.
The area displayed by the camera is limited.
It does not display objects that are close to either corner or under the
bumper and can vary depe ...
Cargo Management System (Wagon Only)
Press the bottom of the load floor
handle assembly to lift the top on
the handle. Pull up on the handle
to open the cargo management
system.
The cover can be opened to two
positions to ...
PARKING ASSIST BLOCKED
SEE OWNER'S MANUAL
If the vehicle has the Ultrasonic
Rear Park Assist (URPA) system,
this message displays if there is
something interfering with the park
assist system. See Ultrasonic
Parking Assist for
mor ...