Windshield Wiper/Washer
The windshield wiper/washer lever is located on the right side of the steering column. With the ignition in ACC/ACCESSORY or ON/RUN/START, move the windshield wiper lever to select the wiper speed.
HI: Use for fast wipes.
LO: Use for slow wipes.
INT: (Intermittent Wipes): Move the lever up to INT for intermittent wipes, then turn thexINT band up for more frequent wipes or down for less frequent wipes. If the vehicle has Rainsense™, see the following Rainsense information.
OFF: Use to turn the wipers off.
(Mist): For a single wipe, briefly move the wiper lever down.
For several wipes, hold the wiper lever down.
Clear snow and ice from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged blades should be replaced. See Wiper Blade Replacement.
Heavy snow or ice can overload the wiper motor.
See also:
Headlamp Wiring
An electrical overload may cause the lamps to go on and off, or in some cases
to remain off. Have the headlamp wiring checked right away if the lamps go on and
off or remain off. ...
TIRE LOW ADD AIR TO TIRE
On vehicles with the Tire Pressure
Monitor System (TPMS), this
message displays when the
pressure in one or more of the
vehicle’s tires is low. This message
also displays LEFT FRONT, RIGHT
...
Conversions and Add-Ons
Add-On Electrical Equipment
Notice: Do not add anything electrical to the vehicle unless you check
with your dealer first.
Some electrical equipment can damage the vehicle and the damage would no ...