Tire Messages
SERVICE TIRE MONITOR SYSTEM
On vehicles with the Tire Pressure Monitor System (TPMS), this message displays if a part on the TPMS is not working properly. The tire pressure light also flashes and then remains on during the same ignition cycle. See Tire Pressure Light . Several conditions may cause this message to appear. See Tire Pressure Monitor Operation for more information. If the warning comes on and stays on, there may be a problem with the TPMS. See your dealer.
TIRE LEARNING ACTIVE
On vehicles with the Tire Pressure Monitor System (TPMS), this message displays when the TPMS is re-learning the tire positions on your vehicle. The tire positions must be re-learned after rotating the tires or after replacing a tire or sensor. See Tire Inspection , Tire Rotation , Tire Pressure Monitor System , and Tire Pressure for more information.
TIRE LOW ADD AIR TO TIRE
On vehicles with the Tire Pressure Monitor System (TPMS), this message displays when the pressure in one or more of the vehicle's tires needs to be checked. This message also displays
LEFT FRT (left front), RIGHT FRT (right front), LEFT RR (left rear), or RIGHT RR (right rear) to indicate the location of the low tire. The low tire pressure warning light will also come on. See Tire Pressure Light . You can receive more than one tire pressure message at a time. To read the other messages that may have been sent at the same time, press the set/reset button or the trip odometer reset stem. If a tire pressure message appears on the DIC, stop as soon as you can. Have the tire pressures checked and set to those shown on the Tire Loading Information label.
See Tires , Vehicle Load Limits , and Tire Pressure . The DIC also shows the tire pressure values. See “DIC Operation and Displays (With DIC Buttons)” earlier in this section.
See also:
Fast facts
1. Base 2.5L 4-cylinder models make 202 hp and 191 lb-ft of torque, with the
2.0T rated at 272 hp and 260 lb-ft and the 3.6L V6 at 321-hp and 275 lb-ft.
2. 0-60 times for each motor list at: 7.5, ...
Exiting the Feature
Settings Menu
The feature settings menu will be
exited when any of the following
occurs:
- The vehicle is no longer in
ON/RUN.
- The trip/fuel or vehicle
information DIC buttons are
pressed.
- The end ...
When to Add Engine Oil
If the oil is below the cross-hatched area at the tip of the dipstick, add 1
L (1 qt) of the recommended oil and then recheck the level. See “Selecting the Right
Engine Oil” in this section for ...






