Starting the Vehicle

1. Aim the Remote Keyless Entry (RKE) transmitter at the vehicle.

2. Press and release 3. Immediately after completing.

3. Immediately after completing Step 2, press and hold least four seconds or until the for at least four seconds or until the vehicle's turn signal lamps flash.

When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running.

The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

    See also:

    Making Turns
    Notice: Making very sharp turns while trailering could cause the trailer to come in contact with the vehicle. The vehicle could be damaged. Avoid making very sharp turns while trailering. When tur ...

    SERVICE PARKING ASSIST
    This message displays if there is a problem with the Ultrasonic Rear Parking Assist (URPA) system. Do not use this system to help you park. See Ultrasonic Parking Assist for more information. ...

    Center Console Storage
    A console compartment is located between the bucket seats. The console has both an upper and lower storage bin accessed by lifting up on the latches located at the front of the console lid. The co ...