Timer
Can be used to measure time.
For example, timing how long it takes to travel from one point to another. To access the timer, press the trip/fuel button until Timer 00:00:00 displays.
To turn on the timer, press the set/reset button.
To turn off the timer, press the set/reset button again. The timer displays the end timing value.
To reset the timer to zero, press and hold the set/reset button.
See also:
Verify Minutes and Expiration
Push and say “minutes” then
“verify” to check how many minutes
remain and their expiration date. ...
When the System Does Not
Seem to Work Properly
The following messages may be
displayed on the DIC:
PARKING ASSIST OFF: This
message occurs if the driver
disables the system or if vehicle is
driven above 8 km/h (5 mph) in
R (Reverse).
S ...
Using Voice Commands
During a Planned Route
Cancel Route
1. Push . System responds:
“OnStar ready,” then a tone.
Say “Cancel route.” System
responds: “Would you like to
cancel route directions to your
destination?”.
2. Say “Yes.” Syst ...